Filter
Top Products
Page 6 - 10
Applications
© GBC Films Group April 2000
F - 160 CE Operation and Maintenance Manual
Parameter Chart 3 - Single sided ( Sled )
TEMPERATURE
GAP & PRESSURE
MOTOR DIRECTION & SPEED
TOP TEMP. BOT. TEMP.
PRESSURE
GAP
SPEED
FWD
REV.
GO
GO
= Panel
SOLID
FLASHING
= Footswitch
PULL ROLL SETTINGS
NOTES
N / A
1/4 Turn
1/2 Turn
3/4 Turn
PRESSURE
MATERIALS
UPPER UNWIND :
LOWER UNWIND :
SUBSTRATE :
PRINTS :
Pro Gloss
N / A
1/4" Foam Core
Inkjet prints
68 68
1/4
00.0
Substrate will vary. Print can be of any type. GAP will be dependent on the substrate thickness. Pressure will
be determined by operator. Speed is not indicated in Footswitch mode. Because the process is described
from the front of the laminator, motor direction is FWD and the pull rolls are not required for this application.
DOWN
UP