Filter
Top Products
Page 4 - 18
Installation F - 160 CE Operation and Maintenance Manual
© GBC Films Group April 2000
4.10 Safety check
The safety check will ensure that all safety devices
and interlocks are functioning properly.
This procedure describes how to check one
E-STOP, the front E-CABLE, the front safety shield
and the front feed table. Repeat the steps for the remaining
three E-STOPS, the rear E-CABLE and the rear safety
shield. The rear feed table is not removable. ALL
SAFETY FEATURES MUST BE CHECKED!
WARNING
Do not wear ties, loose fit clothing or
dangling jewelry while operating or
servicing the laminator. These items can get
caught in the nip and choke you or you can
be crushed or burned.
WARNING
If a safety feature is not working
properly, contact your local service
representative immediately.
Contacts:
GBC National Service: ( 800 ) 790 - 7787
GBC Europe Service: 33 - 45 - 535 - 7676
4.10.1 Front feed table
a) Turn MAIN POWER to “ON” .
Power
ON/OFF
b) Press RESET. The front control panel will be
illuminated.
Machine reset
c) Press SEL. SEL stops flashing.
= Flashing
JOB
STANDBY
SAV
0
SEL