Filter
Top Products
Page 5 - 16
Operations F - 160 CE Operation and Maintenance Manual
© GBC Films Group April 2000
5.4 Job programming
The job save feature is very convenient if the same
parameters are required to perform various applications.
This procedure will guide you step by step through this
feature.
a) Follow the prcedure in Section 5.3.1 Power.
INFORMATION
When the laminator is first turned on, the
front control panel will go into the default
mode.
Default mode; TOP TEMP. = 68
o
F ( 20
o
C ),
BOT. TEMP. = 68 oF ( 20 oC ), GAP = 1 in.,
PRESSURE = no bars are solid, JOB = 0, no
motion direction selected, SPEED = 00.0 and
SLEEP = flashing
b) Press JOB ▲ to enter the desired job number
for the parameters you require to be stored.
JOB
STANDBY
SAV
1
SEL
c) Press SEL.
JOB
STANDBY
SAV
1
SEL
d) If heat is required, press TOP TEMP. ▲ and
BOT. TEMP. ▲ to desired settings. If no heat
is required, leave the settings at 68
o
F ( 20
o
C ).
225 225
TOP TEMP BOT TEMP
--
WARNING
Keep hands and fingers clear of the
laminator roller nip when changing GAP.
You can be CRUSHED or BURNED!
e) Enter in the GAP setting desired by pressing
GAP ▼.
0
GAP
PRESSURE