Filter
Top Products
Page 8 - 3
MaintenanceF - 160 CE Operation and Maintenance Manual
© GBC Films Group April 2000
c) Press SEL.
JOB
STANDBY
SAV
0
SEL
= Flashing
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
WARNING
d) Open the front and rear safety shields.
e) Remove the front feed table.
Removing adhesive build up
a) For pressure sensitive adhesives: put on the
rubber gloves and use isopropyl alcohol and a
terry cloth towel.
b) For thermal adhesives: while the laminator is at
normal operating temperature, put on the rubber
gloves and use the rubber cement eraser. This
allows the eraser to bead up the adhesive.
CAUTION
Excessive pressure can destroy the silicone
layer by pressing to hard or scrubbing
too long in one spot.
c) Wipe away the beads with isopropyl alcohol
and a cotton terry cloth.
CAUTION
Do NOT pick or pull heat activated adhesive
off the rolls when they are cold. You can
cause irreparable damage to the
laminating rolls.