Filter
Top Products
Page 5 - 13
Operations
F - 160 CE Operation and Maintenance Manual
© GBC Films Group April 2000
c) Swing the unwind shaft out enough to slide the
roll of laminate over the core chucks and onto
the unwind shaft.
Core chucks
Core support
Clevis pin
Brake adjust knob
Roll of laminate
Saddle
INFORMATION
Twisting the roll of film while sliding
makes loading the film onto the
unwind shaft easier.
d) Onceloaded, swing the unwind shaft back into
the saddle.
Ensure the roll of laminate is loaded
properly on the unwind shaft.
Exposed adhesive should be facing
away from the rollers.
This will prevent hours of roll cleaning!
CAUTION
e) Push the clevis pin back down to secure the
unwind shaft its saddle.
f) Now you must center the roll of laminate on the
unwind shaft. For centering measurements,
refer to Chart 5.3.1 Measurement chart.
Measure from
the side frame
to the edge of
the roll of
laminate.
Make sure
the laminate
is flush with
the core.
h) Close the rear safety shield.
g) For the lower unwind shaft, repeat steps “ b ”
through “ f ”.