Filter
Top Products
Page 5 - 12
Operations F - 160 CE Operation and Maintenance Manual
© GBC Films Group April 2000
5.3 Set up
Initial set up of the Falcon 160 CE laminator is
easily attained when instructions are followed exactly. It
is suggested and helpful if you take the time to read this
section thoroughly before attempting to do any of the steps.
A complete understanding of this section will enable you
to follow the procedures descibed in Section 6.1
Application.
5.3.1 Power
a) Clear the area around the laminating rollers and
pull rollers nip..
b) Ensure the laminator is plugged in.
c) Turn the MAIN POWER to the “ I ”
position.
Power
ON/OFF
d) Press machine RESET. The front control panel
is illuminated.
Machine reset
5.3.2 Film loading
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
WARNING
a) Raise the rear safety shield if placing a roll of
laminate onto the upper unwind shaft.
b) Lift the clevis pin located in the saddle of the
upper unwind shaft.