Filter
Top Products
Page 4 - 12
Installation F - 160 CE Operation and Maintenance Manual
© GBC Films Group April 2000
Lowering is limited to the amount of
height within the inside of the leg.
INFORMATION
c) Position the level on the top of the drive side
frame. Not on the cabinet. Refer to Figure
4.8.2 Front to back drive side
Figure 4.8.2 Front to back drive side
Level
d) Level the control side from front to back by
holding the nut inside the leg and turning the nut
below the leg with the wrench.
INFORMATION
A second person can read the level while you
make the appropriate adjustments.
- To raise; raise the nut inside the leg and turn
the nut below the leg clockwise.
Raise
Turn clockwise
- To lower; turn the nut below the leg counter
clockwise.
Turn counter
clockwise
Lowering
limit
e) Confirm that power is supplied to the
laminator.