Filter
Top Products
Page 6 - 16
Applications
© GBC Films Group April 2000
F - 160 CE Operation and Maintenance Manual
Parameter Chart 6 - Decal and mount ( Mount )
TEMPERATURE
GAP & PRESSURE
MOTOR DIRECTION & SPEED
TOP TEMP. BOT. TEMP.
PRESSURE
GAP
SPEED
FWD
REV.
GO
GO
= Panel
SOLID
FLASHING
= Footswitch
PULL ROLL SETTINGS
NOTES
N / A
1/4 Turn
1/2 Turn
3/4 Turn
PRESSURE
MATERIALS
UPPER UNWIND :
LOWER UNWIND :
SUBSTRATE :
PRINTS :
N / A
N / A
1/4" Foam Core
Decals
68 68
1/4
00.0
Decal will come from the previous chart and diagram application. Substrate can vary. GAP will be dependent
on the substrate thickness. Pressure will be determined by operator. Speed is not indicated in Footswitch
mode. Because the process is described from the front of the laminator, motor direction is FWD and the pull
rolls are not required for this application.
DOWN
UP