Filter
Top Products
Page 5 - 25
Operations
F - 160 CE Operation and Maintenance Manual
© GBC Films Group April 2000
5.6.2 Replacing the infeed
table
a) Ensure the safety shiled is in the raised
position.
b) With both hands, grip the front edge of the
infeed table and align the back edge with the
support bolts.
Front
support bolt
c) Now lower the front edge while ensuring that
the pin aligns with the safety roller switch and
the back support bolt. Refer to Figure 5.6.3
Back
support bolt
Safet
y
roller switch
If the tables are not properly seated, the
laminator will not operate in
"Panel" mode.
INFORMATION