Filter
Top Products
Page 4 - 14
Installation F - 160 CE Operation and Maintenance Manual
© GBC Films Group April 2000
WARNING
Keep hands and fingers clear of the
laminator roller nip when changing GAP.
You can be CRUSHED or BURNED!
j) Press PRESSURE ▼ to illuminate 3 bars in
the pressure dsiplay.
0
GAP
PRESSURE
k) Place the level across the top of the upper main
roller in the center. Refer to Figure 4.8.3
Drive to control side front
Figure 4.8.3 Drive to control side front
Level
l) Level the laminator from drive side to control
side by adjusting the two front leveling pads.
- To raise; raise the nut inside the leg and turn
the nut below the leg clockwise.
Raise
Turn clockwise
- To lower; turn the nut below the leg counter
clockwise.
Turn counter
clockwise
Lowering
limit
n) Press GAP
▲▲
▲▲
▲ to 1 in. setting.
1
GAP
PRESSURE