Filter
Top Products
Page 4 - 15
InstallationF - 160 CE Operation and Maintenance Manual
© GBC Films Group April 2000
m) Turn the pull roller lift handle towards the rear
of the machine to lower the upper pull roller.
Stop after initial contact with the lower pull
roller plus 1/2 turn.
n) Raise the rear safety shield
o) Place the level across the top of the upper pull
roller in the center. Refer to Figure 4.8.4
Drive to control side rear
Figure 4.8.4 Drive to control side rear
Level
p) Verify all four leveling points. Make any
adjustments neccessary. If all four points are
leveled, secure all nuts in place.
q) Lower the front and rear safety shields.
r) Turn MAIN POWER to “OFF “.
4.9 Connecting power
ELECTRICAL
SHOCK
Only a qualified electrician should connect
power to the laminator. You can be severely
shocked, electrocuted or cause a fire if
power is improperly applied.
a) Ensure the power at the junction box is in the
OFF position.
b) Remove the drive side leg cover with a #2
phillips screw driver.