Filter
Top Products
Page 5 - 6
Operations F - 160 CE Operation and Maintenance Manual
© GBC Films Group April 2000
( 25 ) FORWARD ▲ : When pressed, signals the
laminator to run in a forward motion and FORWARD ▲
becomes solid.
SPEED
SAFETY
FWD
REV
00.0
STOP
GO
25
( 26 ) REVERSE ▼ : When pressed, signals the
laminator to run in a reverse motion and REVERSE ▼
becomes solid.
SPEED
SAFETY
FWD
REV
00.0
STOP
GO
26
( 27 ) SAFETY : Begins flashing anytime the front or the
rear safety shield is in the raised position. This is an
indication for the operator to be very careful when
operating the laminator in the “Footswitch” mode.
SPEED
SAFETY
FWD
REV
00.0
STOP
GO
27
( 28 ) Variable Speed Footswitch : The variable speed
footswitch, operates the laminator in “Footswitch” mode.
Within this mode, if the safety shield is up, speed is
determined by the variable speed footswitch but limited
to the speed set in the display. If the safety shield is down,
the speed is controlled through the control panel.
ATTUNG
WARNING
ADVERTENCIA
28
Panel to Footswitch
1. To switch from “Panel” mode ( GO is solid ) to
“Footswitch” mode ( GO is flashing ) with the safety
shields in the down position. Perform the following
steps;
• Press on the variable speed footswitch. GO
begins flashing identifying “Footswitch” mode.
• Once the variable speed footswitch is released,
the rollers will stop.
• To make the rollers turn, simply press on the
variable speed footswitch.