Filter
Top Products
Page 8 - 5
MaintenanceF - 160 CE Operation and Maintenance Manual
© GBC Films Group April 2000
c) Press SPEED ▲ to enter a speed of 3.
SPEED
SAFETY
FWD
REV
3.0
GO
STOP
CAUTION
Use only isopropyl alcohol or rubber cement
eraser to clean the rollers. Harsh chemicals
like toluene, acetone, or MEK can destroy
the silicone covering of the rolls.
d) With the rubber gloves on, clean the rolls
using a moderate amount of 80% isopropyl
alcohol on a cotton terry cloth.
CAUTION
Exercise care when cleaning the laminating
rollers with 80% isopropyl alcohol:
Use only in a well ventilated area
Wear rubber gloves
Use only on cool rolls
CLEANING HEATED ROLLERS CAN
IGNITE THE FUMES!
WARNING
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
You may be CRUSHED or BURNED!
e) Since the safety shields are raised and the table
removed, you must use the footswitch to rotate
the bottom rollers after cleaning a section.
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
CAUTION
Method 2
a) Allow the laminator to cool slightly to no
higher than 110
o
F ( 43
o
C ).
TOP TEMP BOT TEMP
--
<110 <110