Filter
Top Products
Trilogy200 clinical manual
90
Viewing the Event Log
From the Main Menu screen, you can select Event Log to access the
Event Log screen.
The event log displays a list of all events that have occurred, such as
ventilator setting changes, ventilator inoperative conditions, alarms,
etc., in chronological order with the most recent events displayed
rst. When the device is in Limited Menu access mode, the event
log is not available. It can be viewed and cleared when in Full Menu
access mode. You can page through the event log if it is multiple
pages. The number of pages appears in the upper right corner of the
panel.
In the event log descriptions, any description beginning with a 1:
or 2: is a prescription change event. The 1 represents a change to a
primary setting and the 2 represents a change to a secondary setting.
This is followed by the setting that was changed.
The last two columns indicate setting and alarm changes. If the entry
is a setting change, the rst column shows the old setting value and
the last column shows the new setting. If the entry is an alarm, the
rst column shows the value that triggered the alarm and the last
column shows the number of seconds that the alarm was active.
Viewing Device Information
From the Main Menu screen, you can select Information to access
the Information screen. You can also view the Information screen by
holding the Down key for 5 seconds. This causes the detailed view
of the Monitor Screen and the Information Menu to be displayed
temporarily. This key sequence is valid from the Monitor Screen while
in Full or Limited Access.
The Information screen provides you with a summary of the current
prescription settings, device settings, and system settings. You can
use the Up/Down buttons to scroll through the information.
Note: In Full Menu access mode,
you can press the Right (Clear)
button to clear the event log if
desired.