Philips 200 Work Light User Manual


 
Trilogy200 clinical manual
50
Position the Device
Place the ventilator on a at, level surface. Or, as an alternative, you
can place the device in the optional in-use bag. The in-use bag is
required for portable use in order to properly secure the ventilator.
Do not operate the ventilator while on its side, upside-down, or in
any other orientation. Make sure that the air inlet on the back of the
device is not blocked. If you block the air ow around the device, the
ventilator may not work properly.
Install the Air Filter
The device uses a gray foam filter that is washable and reusable. The
reusable filter screens out normal household dust and pollens. The
filter must be in place at all times when the device is operating. Two
reusable gray foam filters are supplied with the device. If the filter is
not already installed when you receive the device, you must install
the filter before using the ventilator.
To install the filter, insert the gray foam filter into the filter area as
shown.
Supply Power to the Device
The device can operate on AC or DC power. The ventilator accesses
power from potential sources in the following order:
AC Power
External Battery
Detachable Battery Pack
Internal Battery
CAUTION
The reusable foam inlet lter is
required to protect the ventilator
from dirt and dust. Wash
periodically and replace when
damaged for proper operation.
Installing the Filter
Note: See Chapter 7 for
information on how to clean
and replace the air lter.