Filter
Top Products
Trilogy200 clinical manual
140
2. Verify that the device handle, SD Card door, and detachable
battery are secure and in good working order.
3. Verify that the rubber feet are on the bottom of the device.
Initial Setup
1. Connect the power cord to the device and then to an AC outlet.
2. Attach the test lung to the patient connection end of the desired
circuit (Active PAP, Active Flow, or Passive).
3. Follow the instructions in Chapter 5 to access the Setup Screen.
Settings and Alarms Tests
Complete the following steps to set up the settings and alarms tests.
1. Setup
A. Settings And Alarms Menu
Modify the settings in the Settings and Alarms menu to match
those shown below in Table 1. If necessary, refer to Chapter 5 for
instructions on modifying ventilator settings.
Setting Value
Dual Prescription O
Circuit Type Active PAP, Active Flow or
Passive
Therapy Mode S/T
AVAPS (passive circuit only) O
IPAP 20 cm H
2
O
EPAP 4 cm H
2
O
Breath Rate 12 BPM
Inspiratory Time 1.6 seconds
Table 1 - Ventilator Settings
in the Settings and Alarms
Menu