Philips 200 Work Light User Manual


 
Chapter 4 Ventilator Setup
53
Detachable Battery Pack
Philips Respironics oers a detachable Lithium-Ion battery pack. To
use the detachable battery pack, snap the battery into place on the
back of the ventilator, as shown in the following illustration. When
the device is not connected to an AC power source or an external
battery, the detachable battery will power the device, if attached.
The length of time the ventilator will operate on battery power
depends on many factors such as device settings, battery charge
level, and condition or age of the battery. When fully charged, a new
battery can power the ventilator for approximately three hours under
typical patient conditions.
Whenever the ventilator is connected to AC power, it will
automatically recharge the detachable battery pack. A completely
discharged detachable battery will reach 80% charge status within 8
hours, when charging at approximately 23˚ C ambient temperature.
Insert and securely latch the detachable battery into the device as
shown below.
Properly Installed
Detachable
Battery
Insert
Detachable
Battery
CAUTION
The detachable and internal
batteries wear out based on
the amount of use (hours or full
charge-discharge cycles). The
battery capacity and life are also
reduced by operation at higher
temperatures.
CAUTION
Only use the Philips Respironics
Trilogy Detachable Battery with
the device.
Attaching the Detachable
Battery
CAUTION
Prolonged operation or storage
at elevated temperatures may
reduce the service life of the
detachable or internal battery
and other internal components
of the ventilator.