Filter
Top Products
Ethernet Ports
RS400 103 ROS™ v3.5
OFF - Turning this parameter OFF will disable Fast Link Detection completely. The switch will
need a longer time to detect a link failure. This will result in a longer network recovery time of up
to 2s. This option should only be used if fast link failure detection is not needed.
Note When Fast Link Detection is enabled, the system prevents link state change processing from
consuming all available CPU resources. If Port Guard is not used, however, it is possible for
almost all available CPU time to be consumed by frequent link state changes, which could have a
negative impact on overall system responsiveness.
3.2.5 PoE Parameters (when applicable)
The Power-over-Ethernet (PoE) configuration and status parameters can be accessed from the
Ethernet Ports submenu.
Figure 71: Accessing PoE Parameters
Figure 72: PoE Parameters Table