Filter
Top Products
VLANs
ROS™ v3.5 182 RS400
6.3.4 VLAN Summary
There are actually 3 ways VLAN can be created in the switch:
Explicit
VLAN is explicitly configured in the Static VLANs list.
Implicit
VLAN ID is a parameter required for different feature configurations (e.g. Port VLAN
Parameters, Static MAC Addresses, IP Interface Type and ID). When such a parameter is set to
some VLAN ID value, appropriate VLAN is automatically created, if doesn’t exist yet.
Dynamic
VLAN learned through GVRP.
Note: Not explicitly created VLAN is always created with IGMP Snooping disabled. If it is desirable for
IGMP to be used on that VLAN, it should be created as Static VLAN with IGMP enabled.
All VLANs, regardless of the way they were created, are shown in the VLAN Summary.
Figure 123: VLAN Summary Table
VID
Synopsis: 1 to 4094
The VLAN Identifier is used to identify the VLAN in tagged Ethernet frames according to IEEE
802.1Q.
Untagged Ports
Synopsis: Any combination of numbers valid for this parameter
All ports that are untagged members of the VLAN.
Tagged Ports
Synopsis: Any combination of numbers valid for this parameter
All ports that are tagged members of the VLAN.