Filter
Top Products
Index
RS400 273 ROS™ v3.5
Values used for presenting power supply status have been derived from RuggedCom specific
MIB for SNMP.
Read Power Supply Status from device using PSStatusCmd:
E.g. A Modbus Request to read multiple registers from location – 0x0043
0x04 0x00 0x43 0x00 0x01
Response may look like:
0x04 0x02 0x00 0x0A
In the above response lower byte of the register shows status of power supplies. As per the
response both power supplies in the unit are functional.
Index
Alarms
Active Alarms ........................................... 238
Critical Failure Relay................................ 238
Passive Alarms ........................................ 238
Using Alarms............................................ 237
CLI Shell Command
clearlogs................................................... 247
dir............................................................. 246
help .......................................................... 246
ipconfig..................................................... 249
ping .......................................................... 247
reset......................................................... 250
Summary.................................................. 245
trace......................................................... 247
type .......................................................... 246
Configuration
TFTP Capture .......................................... 254
XModem Capture..................................... 254
CoS
Configuration............................................ 187
CoS (Classes of Service) Operation ........ 185
DSCP ....................................................... 191
DHCP Relay .................................................. 48
Diagnostics
CPU Diagnostics...................................... 239
Product Information.................................. 242
System Log .............................................. 241
DNP Configuration......................................... 80
DSCP........................................ See CoS:DSCP
Ethernet
Link Detection .......................................... 102
Loss-of-Link Management ..........................93
PoE...........................................................103
Port Configuration.................................93, 95
Port Mirroring............................................100
Port Rate Limiting .......................................99
Resetting Ports .........................................109
Troubleshooting Ports...............................109
Factory Default Configuration, Loading ........243
FEFI................................................................93
Firmware
TFTP Client Upgrade................................253
TFTP Server Upgrade ..............................252
XModem Upgrade.....................................251
GVRP ....................................See VLAN:GVRP
IGMP ............................................................195
Active and Passive Mode .........................196
Configuration ............................................200
Consumers and Producers.......................195
general membership query.......................196
group-specific membership query.............196
leave group message ...............................196
membership report....................................196
Operation..................................................195
Interface...............................................See ROS
Layer 3 switches, Using................................169
LLDP.............................................................213
Configuration ............................................214
Operation..................................................213
MAC Addresses
Configuring ...............................................209
Learning Options ......................................209