Filter
Top Products
Installation 2
Series N6700 User’s Guide 31
The following figure shows the connections for 50A power modules.
Grouping the Outputs
NOTE
The ability to group outputs is only available on power system mainframes with
firmware revision B.00.00 and up.
Once outputs have been connected in parallel, they can be configured
or “grouped” to act as a single, higher-power channel. This applies
when programming via the front panel or using SCPI commands.
How to group output channels that have been connected in parallel is
discussed in Chapter 4 under “System-Related Operations”.
OUTPUT 2 OUTPUT 1
+S + -S
LOAD
+S + -S
WITH LOCAL SENSING
+
OUTPUT 1
+S + -S
OUTPUT 2
+S + -S
WITH REMOTE SENSING
TWIST
LEADS
LOAD
+
SENSE
JUMPERS
INSTALLED
TWIST LEADS
SENSE
JUMPERS
INSTALLED
WITH LOCAL SENSING WITH REMOTE SENSING
SENSE
JUMPERS
INSTALLED
++
OUTPUT 1OUTPUT 3
LOAD
+
TWIST LEADS
+S +LS -LS -S
++
OUTPUT 1OUTPUT 3
LOAD
+
TWIST
LEADS
+S +LS -LS -S +S +LS -LS -S +S +LS -LS -S