Filter
Top Products
3 Getting Started
38 Series N6700 User’s Guide
Using the Front Panel Menu
The front panel command menu lets you access most of the power
system’s functions. The actual function controls are located at the
lowest menu level. Briefly:
Press the Menu key to access the command menu.
Press the navigation keys to move across the menu commands.
Press the center (Sel) key to select a command and move down to
the next level in the menu.
Press the Help key at the lowest menu level to display help
information about the function controls.
A map of the front panel command structure is found in Chapter 1.
The following example shows you how to navigate the front panel
command menu to program the over-voltage protection function.
Set the Over-Voltage Protection
The over-voltage protection function turns off the affected output if
the output voltage reaches the programmed over-voltage limit.
Menu
Press the Menu key to access the front panel command menu.
The first line identifies the output channel that is being controlled followed
by the menu path. Since the top level is displayed, the path is empty.
The second line indicates the commands that are available at the present
menu level. In this case, the top-level menu commands are shown, with the
Output command highlighted.
The third line indicates which commands are available under the Output
command. Selecting the highlighted command accesses this lower level.
Sel
Press the right arrow f navigation key to traverse the menu until the Protect
command is highlighted. Press the Sel key to select the Protect command.
Sel
The menu path now shows that the commands shown on the second line are
located under the Protect command. The OVP command is highlighted. The
third line indicates which functions are located under the OVP command.
Press the Sel key to select the OVP command.