Filter
Top Products
Speed Drop-down List Box
Selects the speed of blinking or text flow. This is effective only when the "Blink,"
"Scroll," or "Scroll in" text type is selected.
You can also enter a value in the text box on the right.
The unit is "fields/blinking" for blinking, "pixels/field" for scroll, and "fields"
(displaying duration) for scroll in.
Hint
1 field is half of 1 frame duration. It is approximately 1/60 of a second in the case of
NTSC, and 1/50 of a second in the case of PAL.
You can save the value by entering the desired name in the drop-down list box and
clicking the Save button (up to 30 settings). The Delete button deletes the selected
setting.
When you specify a value that is not pre-defined and do not save it, the system
automatically attempts to save the value with the name "User defined." A confirmation
message appears when you click [OK] in the Properties dialog box. Click [Yes] to
specify that value.
Number Text Box and Loop Check Box
Specifies the number of times an item of text displays. Checking the Loop check box
repeats text display during the event.
Position Drop-down List Box
Selects the text position. You can also enter a coordinate (unit: pixels, the top left
corner of the screen is (0,0).) in the text boxes for the position where you want the
upperleft corner of the "constant" or "blink" text to be, and a Y coordinate for the
"scroll" or "scroll in" text. You can save the coordinates by entering a name in the
Position drop-down list box and clicking the Save button (up to 30 settings). The
Delete button deletes the selected setting.
When you specify a coordinate that is not pre-defined and do not save it, the system
automatically attempts to save the coordinate with the name "User defined." A
confirmation message appears when you click [OK] in the Properties dialog box. Click
[Yes] to specify that coordinate.
Note
• The settings for the number and position will be used with urgent text playout only.
Normally, specify the number and position of each text event on the playlist.
• If you selected the "over-scan" display type upon group setting, the system adjusts
the pre-defined positions, such as "Upper" and "Lower," so that the text can be
correctly displayed on over-scan displays.
Note that if you use both over-scan and under-scan displays in a single network
player group, text may not displayed at the expected position on some of the
displays.
• The user-defined position settings saved here (up to 30 settings) are shared with the
Text Position drop-down list box in the Display Setup dialog box displayed for
editing playlists. You are not allowed to specify more than one user setting with the
same coordinate. For a "scroll" or "scroll in" text, the X coordinate, even if you
specify a user setting with an X coordinate setting that is not "0," will be ignored.
110