Filter
Top Products
Performing Tests
Overview
Chapter 4
55
Performing Tests
Running Tests
NOTE Before starting to run operational tests, make certain that you have set PARAMETER
23. ZZZZ Test Demo Mode [0=normal 1=demo] to 0.
You are now ready to select and run tests. On the Test Selections Menu screen, scroll to
the test that you wish to run, and press the knob to select it. The test will run. You may
then select another test and run it in the same manner. You may repeat this operation as
many times as is necessary.
After successfully running the tests, it is recommended that you save all of the
configuration information as a procedure file on an SRAM card for later retrieval (see
“Saving/Deleting a Procedure” on page 101). This eliminates the requirement for
re-entering the information if you run a different program, change parameters when
testing another Base Station, or install new operating system firmware in the Test Set.
For More Information
For more details on the tests in this chapter:
• “Parameters” on page 110
• “Specifications (Pass/Fail Limits)” on page 115
If there were problems or error messages were displayed when running a test:
See Chapter 6, “Troubleshooting,” on page 119.