Filter
Top Products
Performing Tests
CDMA Analyzer Test
Chapter 4
O:\Manuals\E6385A_Cdma\Book\perf-tst.fm
74
Step 3. Follow the displayed instructions and diagram to select and make the measurement.
NOTE This procedure might include steps that prompt you to disconnect cables from the site
antenna ports and make connections to the Test Set. Before removing or re-installing the
antenna cables, make certain that the transmitter has been turned off by the MSC (or by
switch personnel if not using a modem). The green ACT LEDs on the ACU and BCR
modules indicate the transmitter is active, and therefore should be off before
disconnecting cables.
Step 4. Select the desired measurement from the displayed list. The Test Software will configure
itself and make the measurement. It might take several seconds before the
measurement results are displayed.
Review the Results
Channel power and average power are displayed as individual measurements.
Additional measurements are displayed if Rho or EVM is selected.
When you have finished using the CDMA analyzer, press the
k5 (Return) key to return to the CDMA Analyzer Choices menu screen.
Press the
k5 (Return) key again and follow the displayed instructions to return to the
Test Selections Menu screen.