Filter
Top Products
Performing Tests
Pilot Only Test
Chapter 4
63
Performing Tests
Review the Results
The Test Software will begin running pilot channel tests on the selected BBA. During the
test, results will be displayed with a failure indication if a measurement falls outside the
specified limits (see Figure 4-4).
To see the pass/fail limits for each data point as it is measured, use the BTS Laptop
Utility program Test Results window.
When the testing is complete, the Test Software will pause to allow you to review the
on-screen test results. Press the
k1 (Proceed) key to return to the Test Selections Menu
screen.
Figure 4-4 Results from the Pilot Only Test Sequence
The “F” (Fail) indicates that the
measured value is outside of the
specified limits. To change limits,
see “Changing Pass/Fail Limits”
on page 98.