Filter
Top Products
Performing Tests
Code Domain Tests
Chapter 4
65
Performing Tests
Select and Run the Test
Perform the Code Domain Tests as follows:
Step 1. From the Lucent CDMA Tests Main Menu screen, select the Test Selections field. The
Test Software will display the Test Selections Menu screen.
Step 2. Select the Code Domain Tests field.
Step 3. Follow the displayed instructions and diagram to make the measurement.
NOTE This procedure might include steps that prompt you to disconnect cables from the site
antenna ports and make connections to the Test Set. Before removing or re-installing the
antenna cables, make certain that the transmitter has been turned off by the MSC (or by
switch personnel if not using a modem). The green ACT LEDs on the ACU and BCR
modules indicate the transmitter is active, and therefore should be off before
disconnecting cables.
Review the Results
The Test Software will begin running code domain tests on the selected BBA. After tests
are performed, test results will begin showing on the display. See Figure 4-5. Failures
will be indicated in the P/F column if a measurement falls outside the specified limits.
If you wish to stop testing before the sequence is complete, press the
k5 (Abort) key.
Depending on the state of the system, it might take as long as 60 seconds for the test to
stop.
Figure 4-5 Final Results from the Code Domain Tests