Filter
Top Products
Reference
Accessing Test Software Functions
Chapter 5
91
Reference
Loading a Test Procedure
Before you begin testing, you must load the Test Software into the Test Set memory (see
Figure 5-2). To load the Test Software, select the location where the procedure currently
resides (in this case, it will be a PC card) and a procedure file name to download into the
Test Set memory. The card comes pre-programmed with at least one procedure.
The first time that you select a procedure, the actual Test Software program is not
loaded into the Test Set memory until you press the Test Set
k1 (Run Test) key. It will
take approximately 20 seconds for the Test Software program to load. The program will
remain in memory after a power-down/power-up cycle, unless it is manually deleted or a
new program is loaded.
Figure 5-2 Loading a Test Procedure
NOTE See “Troubleshooting the Test Software Installation” on page 121 for some hints to help
debug any problems that you might have during the installation of the Test Software.
Selects the location
and file name of the
test procedure and its
associated library file.