Filter
Top Products
SUMMARY OF WELDING
PROCESSES AND MACHINE
SETTINGS
Table B.3 summarizes the requirements for various
welding processes you can perform with the
RANGER 10-LX.
OPERATION
B-13 B-13
RANGER 10-LX
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
TABLE B.3 - SUMMARY OF WELDING PROCESSES
Process Control Idle Output Wire Electrode To Start Welding
Cable Mode Control Feeder State When
Used Switch Switch Not Welding
Stick – CC No Auto At Welder No Hot Touch electrode to work.
Control Welding starts immed-
Cable ately and engine goes to
high idle.
TIG - CC Yes Auto Remote With Cold Press Amptrol. Welding
K930-1/K936-1 Control starts immediately.
(With Amptrol) Cable
Wire Feed - CV, Yes Auto Remote With Cold Press gun trigger,
LN-25 with 42V Control RANGER 10-LX contactor
Remote Control Kit Cable closes. Welding starts
immediately and engine
goes to high idle.
Wire Feed - CV No Auto At Welder No Cold Press gun trigger, LN-25
LN-25 with internal Control contactor closes. Weld-
contactor Cable ing starts immediately
and engine goes to high
idle.
Wire Feed - CV, Yes High Remote With Cold Press gun trigger,
LN-7 or LN-8 Control RANGER 10-LX contactor
Cable closes. Welding starts
immediately.