Filter
Top Products
Read this entire installation section before you
start installation.
SAFETY PRECAUTIONS
Do not attempt to use this equipment until you have
thoroughly read all the operation and maintenance
manuals supplied with your machine. They include
important safety precautions; detailed engine starting,
operating, and maintenance instructions; and parts
lists.
ELECTRIC SHOCK can kill.
• Do not touch electrically live
parts or electrodes with your
skin or wet clothing.
• Insulate yourself from the work
and ground.
• Always wear dry insulating
gloves.
ENGINE EXHAUST can kill.
• Use in open, well ventilated
areas or vent exhaust to the out-
side.
• Do not stack anything on or near
the engine.
MOVING PARTS can injure.
• Do not operate this equipment
with any of its doors open or
guards off.
• Stop the engine before servicing
it.
• Keep away from moving parts.
Only qualified personnel should install, use, or ser-
vice this equipment.
LOCATION AND VENTILATION
Whenever you use the RANGER 10-LX, be sure that
clean cooling air can flow through the machine’s diesel
engine and the machine case. Avoid dusty, dirty
areas. Also, keep the machine away from heat
sources. Do not place the back end of the generator
anywhere near hot engine exhaust from another
machine. And of course, make sure that engine
exhaust is ventilated to an open, outside area.
The RANGER 10-LX may be used outdoors. Do not
set the machine in puddles or otherwise submerge it in
water. Such practices pose safety hazards and cause
improper operation and corrosion of parts.
Always operate the RANGER 10-LX with the case roof
on and all machine components completely assem-
bled. This will protect you from the dangers of moving
parts, hot metal surfaces, and live electrical devices.
STORING
1. Store the machine in a cool, dry place when it’s
not in use. Protect it from dust and dirt. Keep it
where it can’t be accidentally damaged from con-
struction activities, moving vehicles, and other
hazards.
2. Drain the engine oil and refill with fresh 10W30 oil.
Run the engine for about five minutes to circulate
oil to all the parts. See the Maintenance section
of this manual for details on changing oil.
3. If you are storing the machine for more than 30
days, drain the coolant from the radiator. Open the
cock at the bottom of the radiator and remove the
pressure cap so that the coolant drains complete-
ly. Attach a note that says “NO WATER” on the
radiator.
4. Remove the battery, recharge it, and adjust the
electrolyte level. Store the battery in a dry, dark
place.
5. If the engine is not used for a long period of time,
every two to three months fill the radiator and run
the engine for about five minutes to keep it free
from rust.
INSTALLATION
A-3 A-3
RANGER 10-LX
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
WARNING