Filter
Top Products
To reinstall the brushes, press them upward and slide
a cable tie or wooden stick through the brush holder
tabs. See Figure D.5. Install the brush holder into
position and secure with the screws previously
removed. Remove the cable tie or wooden stick and
the brushes will seat onto the slip rings.
RECEPTACLES: Keep the electrical receptacles in
good condition. Remove any dirt, oil, or other debris
from their surfaces and holes.
CABLE CONNECTIONS: Check the welding cable
connections at the weld output terminals often. Be
sure that the connections are always tight.
MAINTENANCE
D-9 D-9
RANGER 10-LX
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
FIGURE D.5 - BRUSH REMOVAL AND REPLACEMENT
1. BRUSHES
2. CABLE TIE
3. RETAINER CLIP