Filter
Top Products
A-9
INSTALLATION
IDEALARC DC-1000
A-9
CONNECTION FOR AIR/CARBON ARC
CUTTING OPERATION
THE OUTPUT TERMINALS ARE ENERGIZED AT
ALL TIMES WHEN THE IDEALARC DC-1000 IS
CONNECTED FOR AIR/CARBON ARC CUTTING.
____________________________________________________
1. Set ON/OFF PUSH BUTTON to OFF.
2. Locate and open the access door on the Front
Case Assembly.
3. If necessary, disconnect all wire feeder control
cable connections from the DC-1000 terminal
strip.
4. Remove the leads from the unit by pulling them
through and out of the strain relief box connector
(s).
5. Connect a jumper wire from terminal #2 to termi-
nal #4 on the terminal strip.
6. Set the Welding Mode Switch to the CV(I) position
for air/carbon arc cutting.
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
WARNING