Filter
Top Products
F-36
TROUBLESHOOTING & REPAIR
F-36
3. Remove the red insulating paint
from heat sink test points. See
Figure F.16.
4. Perform test procedure as follows.
Refer to Figure F.17. Repeat test
for all six SCRs.
NOTE: Do not disassemble the heat
sinks.
ACTIVE SCR TEST
IDEALARC DC-1000
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
FIGURE F.16 - Heat Sink Assembly Test Points