Filter
Top Products
Workman 200 Ultra Sonic Boom System (Rev. C)Page 3.2 -- 3
Special Tools
Diagnostic Display
The Diagnostic Display (Fig. 1) can be connected to the
Ultra SonicBoom wire harness communication connec-
tor to verify correct electrical functions of the UltraSonic
Boom System. Toro electronic controller (TEC) inputs
and outputs for the Ultra Sonic Boom System can be
checked using the Diagnostic Display.
Toro Part Number for Diagnostic Display: 85 --4750
Toro Part Number for Overlay (English): 119--9431
IMPORTANT: The Diagnostic Display must not be
left connected to the machine. It is not designed to
withstand the environment of the machine’s every
day use. When use of Diagnostic Display is com-
pleted, disconnect it from the machine and recon-
nect loopback connector to wire harness
communication connector. Machine will not oper-
ate without loopback connector installed on wire
harness. Store Diagnostic Display in a dry, secure,
indoor location and not on machine.
Figure 1
Figure 2
119--9431
Ultra Sonic
Boom System