Filter
Top Products
91
Dukane Manual Part No. 403–566–01
Section 8 – Process Limits Menu
For a dual–pressure mode, both the normal limits and
the total limits are displayed as shown in Figure 8–5.
In the flowchart, the single–pressure limits are on
the right side and the dual–pressure total limits sec-
tion are in the shaded area on the left side.
Single Pressure Mode
If a single–pressure mode has been programmed,
the limits begin with the selection of Time or En-
ergy in the Process Limits menu (Figure 8–3).
Pressing the ENTER key displays the limit param-
eter selection which is shown in Figure 8–6.
TIME
ENERGY
TOTAL TIME
TOTAL ENERGY
Total Limits
Available Only in
Dual Pressure Mode
TIME
ENERGY
TOTAL TIME
TOTAL ENERGY
PROCESS
LIMITS
WELD
TIME P2
WELD
TIME P1
PROCESS
LIMITS
WELD
ENERGY P2
WELD
ENERGY P1
TOTAL
WELD TIME
TOTAL
WELD ENERGY
LIMIT DEFINITION
SUSPECT
BAD
LIMITS
ENTER
ENTER ENTER
ENTER
ENTER
ENTER ENTER
ENTER
ENTERENTER
ENTER ENTER
ENTER
ENTER
ENTER ENTER
ENTER
Dual
Pressure
Mode?
NO
YES
2P?
Dual
Pressure
Mode?
NO
YES
2P?
In Dual Pressure mode, the
Weld Methods can be mixed
T
1
max
T
1
min
T
2
max
T
2
min
E
1
max
E
1
min
E
2
max
E
2
min
T
max
T
min
E
max
E
min
PROCESS
LIMITS
PROCESS
SETUP
ENTER
Figure 8–1
Figure 8–2
Figure 8–3
Figure 8–5
Figure 8–4 Limit Definition Flow Chart
Figure 8–5 Dual–Pressure Process Limits Menu