Filter
Top Products
79
Dukane Manual Part No. 403–566–01
Section 7 – Process Control Menu
Using the four arrow keys, enter the weld time. Press
the ENTER key when you have completed the data
entry. This displays the Weld Method selection
screen for Pressure Two as shown in Figure 7–41.
This time select WELD BY ENERGY and press the
ENTER key. This brings up the data entry screen
for pressure two as shown below in Figure 7–42.
If you do not have a Power Output module, the
energy option will not appear. Figure 7–44 shows
the logical flow for dual pressure mode without
the energy option.
Again use the arrow keys to enter the weld en-
ergy. This parameter is labeled E
2
weld
on the flow
chart. Press the ENTER key when you have fin-
ished to bring up the data entry screen for P2
Maximum Weld Time as shown in Figure 7–43.
This value sets the time limit to reach the P2 weld
energy. This time limit applies only to the P2 cycle.
WELD METHOD P2
WELD BY TIME
WELD BY ENERGY
WELD ENERGY P2
75 J
MAX WELD TIME P2
0.350 SEC
PROCESS CONTROL
WELD MODE
HOLD TIME
AFTERBURST
If we select energy for the P1 cycle, it will have
its own maximum weld time limit. Press the
ENTER key to return to the Process Control
menu as shown in Figure 7–45.
WELD MODE
SINGLE PRESSURE
DUAL PRESSURE
WELD TIME P1
0.500 SEC
WELD TIME P2
0.250 SEC
Dual Pressure Weld Mode Menus
w/o Power Output Module
Figure 7–41 Pressure Two Weld Method Selection Menu
Figure 7–42 Pressure Two Weld Energy Data Entry
Figure 7–43 Pressure Two Max Weld Time Data Entry
Figure 7–44 Dual Pressure Time Only Menus
Figure 7–45 Second Pass Through Process Control Menu