Filter
Top Products
60
Dukane Manual Part No. 403–566–01
DPC
™
II Plus and EZ Welder System – User’s Manual
Limit Definition Menu
The Limit Definition menu has two classes of
settings. The first class is the suspect limits and
the second class is for bad part limits. When
applicable, choices for time, energy, total time
and total energy are available. A simplified flow
chart for the Limit Definition menu is shown in
Figure 6–7. Although not indicated in this draw-
ing, both upper and lower bounds can be set for
each limit. The Limit Definition menu is cov-
ered in greater detail in Section 8.
Total Limits
Available Only with
Press Controller in
Dual Pressure Mode
LIMIT DEFINITION
SUSPECT
BAD
TIME
ENERGY
TOTAL TIME
TOTAL ENERGY
PROCESS
LIMITS
WELD
TIME P2
WELD
TIME P1
PROCESS
LIMITS
WELD
ENERGY P2
WELD
ENERGY P1
TOTAL
WELD TIME
TOTAL
WELD ENERGY
LIMITS
PROCESS
LIMITS
PROCESS
SETUP
Figure 6–7 Limit Definition Menu Flowchart