Filter
Top Products
80
Dukane Manual Part No. 403–566–01
DPC
™
II Plus and EZ Welder System – User’s Manual
HOLD TIME
0.500 SEC
PROCESS CONTROL
WELD MODE
HOLD TIME
AFTERBURST
AFTERBURST
DISABLE
ENABLE
AFTERBURST DELAY
0.150 SEC
AFTERBURST DURATION
0.250 SEC
From here on, the menu follows the same logical
sequence as Auto Probe. Hold Time is automatically
selected for the second pass through Process Con-
trol. Press the ENTER key to display the Hold Time
data entry menu as shown in Figure 7–46. Enter a
value for the hold time and press the ENTER key.
We return for a third time to the Process Control
menu. This time the Afterburst option is automati-
cally selected as shown in Figure 7–47.
Press the ENTER key to display the Afterburst
menu. This permits you to enable or bypass the
afterburst option. To bypass the afterburst option,
select DISABLE and press the ENTER key. You
then jump back to Process Control as shown in
Figure 7–51. To select an afterburst, move the cur-
sor down to ENABLE as shown in Figure 7–48
and press the ENTER key.
PROCESS CONTROL
WELD MODE
HOLD TIME
AFTERBURST
The data entry screen for the afterburst delay ap-
pears as shown in Figure 7–49. Enter a value for
the delay time and press the ENTER key.
The data entry screen for the afterburst duration
appears as shown in Figure 7–50. Enter a value
for the burst time and press the
ENTER key.
The Process Control menu screen appears again
with Weld Mode selected. This screen below in
Figure 7–51 looks just like Figure 7–37.
Figure 7–46 Press Hold Time Data Entry
Figure 7–48 Press Afterburst Enable Menu
Figure 7–47 Third Pass Through Process Control Menu
Figure 7–49 Press Afterburst Delay Data Entry
Figure 7–50 Press Afterburst Duration Data Entry
Figure 7–51 Return To Process Control Menu