Filter
Top Products
7 - 5
GSM Section
If there is no GSM radio installed in the terminal, disable this section. Double tap or click on any Key to get full
information or to edit the settings.
System Section
The System section contains child sections that configure various system settings. Double tap or click on any Key to get full
information or to edit the settings.
About Section
The About section sets a unique device name and description for the terminal. By default, this section is enabled and
applied to the terminal after each reboot.
DeviceName Restrictions
• The DeviceName must begin with a letter.
• The DeviceName cannot exceed 15 characters in length.
• Any text outside brackets (“[xxxx]”) will appear as text in the Device name field.
The following appears in the Device name field:
[SERIALNUMBER] The terminal’s serial number pulled dynamically from the kernel.
This is the serial number that appears in SysInfo (see page 13-1).
[MODELNUMBER] The terminal’s model number pulled dynamically from the kernel.
This is the serial number that appears in SysInfo (see page 13-1).
Power Management Section
The Power Management section contains child sections that configure various Backlight and Power Timeout settings
by power source (i.e., Battery, External or USB) and enabling or disabling the Power Button. Double tap or click on any
Key to get full information or to edit the settings.
Priv Key
Password
Private keys can be locked by passwords. Enter the password that unlocks
the private key.
WEP Key Mode
Mode being used by the WEP keys (in Key1–
Key4 keys).
Key validation occurs when DeviceConfig is
loaded on the terminal (often during AutoInstall),
not when you save the DeviceConfig.exm file.
ASCII uses all alpha numeric
characters.
HEX uses only numerics and A-
F.
Valid lengths are as follows:
• 64-bit ASCII=5
• 128-bit ASCII=13
• 64-bit HEX=10
• 128-bit HEX=26
WEP Key1–Key4
In fields Key 1—Key 4, enter the specific key.
The format of each key must match the key
length type selected in the WEP Key Mode key.
To use dynamic keys in your configuration, leave
all the key fields blank.
User-defined
Active Key
Enter the number of the key that you want to be
active in this configuration.
1, 2, 3, or 4
Key Description Available Values