Filter
Top Products
11 - 3
Command Line Arguments
The following command line arguments can be used in the CommandArgs key of the EZPairing section of the
PowerToolsMenu.exm file.
Passcode
Set the passcode for the remote device.
ShowStatus
Enable or disable status dialogs.
ShowError
Enable or disable error messages.
SoundConnect
Enable or disable audio notification when EZ Pairing connects or disconnects. Sounds are
set through the Connect and Disconnect entries in the Sound & Notification control panel
applet.
ScanWedgeOnConnect
Enable or disable automatic launching of ScanWedge on connect.
BarcodeOnDisconnect
Enable or disable automatic display of EZ Pairing bar code on disconnect.
BarcodeText
Set the user text displayed when the connection bar code is generated.
BarcodeRotate
Enable or disable bar code rotation. The barcode text and the Close Barcode button do not
show when BarcodeRotate is enabled.
BarcodeResident
Enable or disable keeping the EZ pairing bar code resident to improve performance. If
enabled, the bar code settings are not refreshed until the EZ Pairing applet is closed and
reloaded.
BarcodeType
Select the bar code type to be generated for initiating EZ Pairing.
AcceptOrDeny
Enable or disable the prompt to accept or deny incoming Bluetooth connections.
/quit Initiates a shutdown of the application.
Key Description
BarcodeRotate Disabled BarcodeRotate Enabled