Filter
Top Products
TROUBLESHOOTING & REPAIR
F-62 F-62
RANGER 250
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
ENGINE/STATOR/ROTOR REMOVAL AND REPLACEMENT (continued)
FIGURE F. 27 – ENGINE STARTER SOLENOID LEADS (ONAN ENGINE SHOWN)
PLASTIC
COVER ON
SOLENOID
STARTER
10. Refer to Figure F.27. Label engine starter
solenoid leads #211A and #209 (#211A
attaches to the solenoid spade terminal and
#209 attaches to the positive stud on the
solenoid along with the positive battery
cable). Pull lead #211A off its spade terminal.
To remove lead #209, you will have to
remove the plastic cover on the starter first.
To do this, use the 1/2" socket wrench to
remove the nut on the negative stud of the
solenoid. Then remove the plastic cover.
Next, remove the 1/2" nut from the positive
solenoid stud. Now you can remove lead
#209 and the positive battery cable from the
starter solenoid.