Filter
Top Products
TROUBLESHOOTING & REPAIR
F-65 F-65
RANGER 250
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
ENGINE/STATOR/ROTOR REMOVAL AND REPLACEMENT (continued)
FIGURE F.30 – STATOR AND ROTOR REMOVAL
8
6
1
2
5
3
4
7
9
Stator/Rotor Assembly Removal
Refer to Figure F.30.
1. Support the stator with the hoist.
2. Using the 1/2" wrench, remove the bolt,
washers, and nut holding the muffler to the
stator (Onan engine machines). Remove the
bolts and washers holding the muffler to the
engine and remove the muffler.
3. Disconnect the idler solenoid linkage at its
clip.
4. Using the 7/16" wrench, remove the two nuts,
lock washers, and bolts holding the brush
holder assembly to the stator frame.
Remove the brush holder assembly.
5. Unscrew the fan to remove it from the shaft.
Turn the fan counterclockwise. Be careful not
to lose the washer that fits between the blow-
er fan and the rotor.
1. STATOR
2. BRUSH HOLDER ASSEMBLY
3. ROTOR THRU-BOLT
4. BLOWER FAN
5. TOLERANCE RING
6. ROTOR BEARING
7. IDLER SOLENOID
8. ROTOR
9. LIFTING EYE