Filter
Top Products
DESIGN FEATURES
• Single, full-range output control dial.
• 4 welding modes: CC-stick, downhill stick welding on
pipe, CV wire welding and Touch-Start TIG™ (elimi-
nates high frequency and tungsten contamination).
• Output at welding terminals controlled by electronic
contactor. Can be switched to “On”, or to “Remotely
Controlled”. Contactor auto-activated when con-
nected. 6-pin connector for remote output.
• Many wire feeder combinations: 14-pin connector for
Lincoln wire feeders LN-25, LN-23P, LN-7, LN-8
operates when using a Lincoln wire feeder with the
appropriate control cable.
• Smart machine! Remote operation and Magnum®
spool gun; 42VAC for LN-742 and Cobramatic® wire
feeders.
• Wire feed voltmeter switch matches polarity of wire
feeder voltmeter to polarity of electrode.
• 12 gallon fuel capacity allows you to run an extend-
ed day.
• Easily check fuel level during operation and refu-
elling with highly visible fuel gauge located next to
the fuel cap on case top side.
• Longer engine life, reduced noise emissions and
greater fuel economy with the automatic engine idler.
• Conveniently located engine maintenance label
under top engine door.
• Engine hour meter for scheduled maintenance.
• Automatic engine shutdown protection for low oil
pressure.
• Electric start. Reduce abnormal charging thanks to
a backlit battery charger system light indicator.
• Oil drain valve (no tools required).
• 8,000 watts of continuous duty AC generator power.
• Up to 33 amps at 240V from the 120V/240V recep-
tacle. Circuit breaker protection.
• Two 120V 20A duplex receptacles. Circuit breaker
protection. Will operate up to a 9” grinder.
CONTROLS AND SETTINGS
The gasoline engine stop/start and idler controls are
located on the case front panel. The welder controls are
also located here. See Figure B.1.
OPERATION
B-3 B-3
RANGER 250
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC