Filter
Top Products
TROUBLESHOOTING & REPAIR
F-64 F-64
RANGER 250
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
ENGINE/STATOR/ROTOR REMOVAL AND REPLACEMENT (continued)
FIGURE F.29 – ENGINE/STATOR/ROTOR ASSEMBLY REMOVAL
LIFTING
EYE (2)
ENGINE
MOUNTING
FIREWALLS
STATOR
SUPPORT
BRACKET
FUEL LINE
Engine/Stator/Rotor Assembly
Removal Procedure
Refer to Figure F.29.
1. Attach chains to the lifting eyes on the top
sides of the engine and the stator lift bail.
Secure the chains to the hoist and put
enough tension on them to support the
engine but without lifting the assembly.
2. Using the 9/16" wrench, remove the two
bolts, lock washers, and nuts from the stator
bottom support bracket and two bolts, wash-
ers and nuts from the engine mountings.
3. Remove the fuel line at the carburetor and
plug it.
4. Using the hoist, you can now lift the
engine/stator assembly free from the
machine base. Note that the firewall baffle
assembly surrounding the muffler (Onan
engine machines) and stator come with the
engine/stator/rotor assembly. It is not
secured to the machine base.
5. Set the assembly carefully on a workbench or
the floor. Place a wooden block under the
stator before removing support from the
hoist.