Filter
Top Products
$DSUACL - SELECTS CLOCKING FOR INTERNAL DSU LINK A.
$DSUBCL - SELECTS CLOCKING FOR INTERNAL DSU LINK B.
$DSUASP - SELECTS SPEED FOR INTERNAL DSU LINK A.
$DSUBSP - SELECTS SPEED FOR INTERNAL DSU LINK B.
EXTERNAL DSU/MODEM
$MUXACL - SELECTS CLOCKING WHEN USING EXTERNAL DSU/MODEM PORT A.
$MUXBCL - SELECTS CLOCKING FROM EXTERNAL SYNC DEVICE ON PORT B.
$MUXASP - SPEED OF THE CLOCK IF SUPPLIED BY THE MULTIPLEXER PORT A.
$MUXBSP - SPEED OF THE CLOCK IF SUPPLIED BY THE MULTIPLEXER PORT B.
$MUXB - SELECTS PORT B AS SYNC DATA CHANNEL OR COMPOSITE LINK.
FOR HELP ON A SPECIFIC COMMAND, ENTER "ATH" FOLLOWED BY THE COMMAND LETTER.
EXAMPLE: ATH$DSUACL "ENTER"
The H4 menu is as follows:
ADDITIONAL COMPOSITE LINK COMMANDS
#C - CLEAR COMPOSITE STATISTICS
$F - LOAD FACTORY DEFAULTS FOR DSU AND ISCC
#FT - FLUSH TIMER VALUE
$L - LIST CONFIGURATION OF PORT A & B
#L - LIST COMPOSITE LINK SETTINGS
#RB - SET AUTO REPORTING BAUD RATE
#RT - SET AUTO REPORTING TIME INTERVAL
#RXT - PROGRAMMABLE RETRANSMIT TIMER
#S - COMPOSITE LINK STATISTICS
#SL - STATUS OF FRONT PANEL LEDS
FOR HELP ON A SPECIFIC COMMAND, ENTER ATH FOLLOWED BY A COMMAND LETTER.
The H5 menu is as follows:
MISCELLANEOUS COMMANDS
I - ID CODE
#MA - MODEM ACCESS FOR COMMAND MODEM
#RA - REMOTE ACCESS FOR COMMAND MODEM
&T - TEST MODES
&W - SAVE PARAMETERS "WRITE TO MEMORY"
Z - RESET MULTIMUX
FOR HELP ON A SPECIFIC COMMAND, ENTER ATH FOLLOWED BY A COMMAND LETTER.
The H6 menu is as follows:
VOICE/FAX CHANNEL COMMANDS
VL - LIST THE VOICE/FAX CHANNEL PARAMETERS
V(1/2)Z - RESET VOICE/FAX CHANNEL
V(1/2)DR - VOICE/FAX CHANNEL DIGITIZING RATE
V(1/2)DC - VOICE/FAX DESTINATION CHANNEL
V(1/2)DN - VOICE/FAX DESTINATION NODE
V(1/2)ML - LINK THE VOICE/FAX CHANNEL WILL COMMUNICATE OVER
V(1/2)OL - VOICE/FAX CHANNEL OUTPUT LEVEL ATTENTUATION
V(1/2)IL - VOICE/FAX CHANNEL INPUT LEVEL GAIN
V(1/2)SS - VOICE/FAX CHANNEL SILENCE SUPPRESSION
COMMAND EXAMPLE 1: ATV1DN2 - SETS THE DESTINATION NODE OF CHANNEL 1 TO 2.
FOR HELP ON A SPECIFIC COMMAND, ENTER ATH FOLLOWED BY A COMMAND LETTER.
The H7 menu is as follows:
ADDITIONAL VOICE/FAX CHANNEL COMMANDS
V(1/2)LI - VOICE/FAX CHANNEL LOCAL INTERFACE
V(1/2)RI - VOICE/FAX CHANNEL REMOTE INTERFACE
V(1/2)WT - VOICE/FAX CHANNEL WINK TIMER