Filter
Top Products
Table 6-2. Command Modem Operating Procedures (Cont.)
Step Procedure
4You are now communicating with your remote MultiMux. Any commands you now execute will be done by the remote
unit. For instance, to request status of the remote system execute the List Channel Parameters
Command by entering the following:
ATL (hit Return)
The following, which will be an actual listing of the remote units channel parameters, will appear on your
supervisory console:
Local Channel Parameters/ Node # 01
STP FLOW ENQ/ PASS PASS DEST DEST LINK
CHN SPD WD BIT PAR CTRL ACK ECHO PACE EIA XON CHN NODE A/B
01 19200 8 1 NONE XON/XOFF OFF OFF OFF OFF OFF 01 02 A
02 19200 8 1 NONE XON/XOFF OFF OFF OFF OFF OFF 02 02 A
03 19200 8 1 NONE XON/XOFF OFF OFF OFF OFF OFF 03 02 A
04 19200 8 1 NONE XON/XOFF OFF OFF OFF OFF OFF 04 02 A
05 19200 8 1 NONE XON/XOFF OFF OFF OFF OFF OFF 05 02 A
06 19200 8 1 NONE XON/XOFF OFF OFF OFF OFF OFF 06 02 A
07 19200 8 1 NONE XON/XOFF OFF OFF OFF OFF OFF 07 02 A
08 19200 8 1 NONE XON/XOFF OFF OFF OFF OFF OFF 08 02 A
OK
To end your call to the remote site you can either terminate the whole command modem operation and put
your supervisory console back into communications with your local MultiMux, or you can end the
current call and remain connected to your command modem for additional remote communications.
To end the current call and place supervisory console control back to the local MultiMux, enter the following command:
AT#MA0 (hit Return)
To end the call and remain connected to your command modem, enter the following command:
+++ (hit Return)
Wait for the OK (0) Result code to be displayed on your supervisory console, then enter the following:
ATZ (hit Return)