Filter
Top Products
Monitoring Tools 11-3
Current status
The current status section is a table showing the current status of the WAN. For example:
Profile Name: Lists the name of the connection profile being used, if any.
State: Lists the ports in use for this connection.
%Use: Indicates the average percent utilization of the maximum capacity of the channels in use for the
connection.
Remote Address: Shows the IP address of the connected remote router if the connection is using IP.
Est: Indicates whether the connection was locally (“Lcl”) or remotely (“Rmt”) established.
More Info: Indicates, in order of priority, the NAT address in use for this connection or the ISDN caller
identification (if available).
Status lights
This section shows the current real-time status of the Netopia R310’s status lights (LEDs). It is useful for
remotely monitoring the router’s status. The Quick View screen’s arrangement of LEDs corresponds to the
physical arrangement of LEDs on the router.
Each LED representation can report one of four states:
–: A dash means the LED is off.
R: The letter “R” means the LED is red.
G: The letter “G” means the LED is green.
Y: The letter “Y” means the LED is yellow.
The section “Netopia R310 ISDN Router Status Lights” on page 2-4 describes the meanings of the colors for
each LED.
Current WAN Connection Status
---Profile Name------State---%Use-Remote Address----Est.-More Info----------
ISP P1 10 IP 92.163.4.1 Lcl NAT 192.163.100.6
-PWR-+-----ISDN------+------------+---------------+--EN--+--------LEDS---------
LNK RDY CH1 CH2 DATA | '-'= Off 'G'= Green
G - G G - | 'R'= Red 'Y'= Yellow