Filter
Top Products
Security 12-19
Deleting a filter set
Note: If you delete a filter set, all of the filters it contains are deleted as well. To reuse any of these filters in
another set, you’ll have to note their configuration before deleting the current filter set and then recreate them.
To delete a filter set, select Delete Filter Set in the IP Filter Sets screen to display a list of filter sets.
Select a filter set from the list and press Return to delete it. Press the Escape key to exit the list without
deleting the filter set.
A sample IP filter set
This section contains the settings for a filter set, called Basic Firewall, which is part of the Netopia R310’s
factory configuration.
Basic Firewall blocks undesirable traffic originating from the WAN (in most cases, the Internet), but passes all
traffic originating from the LAN. It follows the conservative “that which is not expressly permitted is prohibited”
approach: unless an incoming packet expressly matches one of the constituent input filters, it will not be
forwarded to the LAN.
Change IP Filter Set
Filter Set Name: Basic Firewall
Display/Change Input Filter...
Add Input Filter...
Delete Input Filter...
Display/Change Output Filter...
Add Output Filter...
Delete Output Filter...