Filter
Top Products
5-4 User’s Reference Guide
with the operating system.
■ If you connect a Macintosh computer, you can use the ZTerm terminal emulation program on the supplied
Netopia R310 CD.
Launch your terminal emulation software and configure the communications software for the following values.
These are the default communication parameters that the Netopia R310 uses.
Parameter Suggested Value
Terminal type PC: ANSI-BBS
Mac: ANSI, VT-100, or VT-200
Data bits 8
Parity None
Stop bits 1
Speed Options are: 9600, 19200, 38400, or 57600 bits per second
Flow Control None
Note: The router firmware contains an autobaud detection feature. If you are at
any screen on the serial console, you can change your baud rate and press
Return (HyperTerminal for the PC requires a disconnect). The new baud rate is
displayed at the bottom of the screen.