Filter
Top Products
Security 12-21
Basic Firewall is suitable for a LAN containing only client hosts that wish to access servers on the WAN, not for
a LAN containing servers providing services to clients on the WAN. Basic Firewall’s general strategy is to
explicitly pass WAN-originated TCP and UDP traffic to ports greater than 1023. Ports lower than 1024 are the
service origination ports for various Internet services such as FTP, Telnet, and the World Wide Web (WWW).
A more complicated filter set would be required to provide WAN access to a LAN-based server. See “Possible
modifications,” below, for ways to allow remote hosts to use services provided by servers on the LAN.
Possible modifications
You can modify the sample filter set Basic Firewall to allow incoming traffic using the examples below. These
modifications are not intended to be combined. Each modification is to be the only one used with Basic Firewall.
The results of combining filter set modifications can be difficult to predict. It is recommended that you take
special care if making more than one modification to the sample filter set.
Trusted host. To allow unlimited access by a trusted remote host with the IP address a.b.c.d (corresponding to
a numbered IP address such as 163.176.8.243), insert the following input filter ahead of the current input filter
1:
■ Enabled: Yes
■ Forward: Yes
■ Source IP Address: a.b.c.d
■ Source IP Address Mask: 255.255.255.255
■ Dest. IP Address: 0.0.0.0
■ Dest. IP Address Mask: 0.0.0.0
■ Protocol Type: 0
Trusted subnet. To allow unlimited access by a trusted remote subnet with subnet address a.b.c.d
(corresponding to a numbered IP address such as 163.176.8.0) and subnet mask e.f.g.h (corresponding to a
numbered IP mask such as 255.255.255.0), insert the following input filter ahead of the current input filter 1:
■ Enabled: Yes
■ Forward: Yes
■ Source IP Address: a.b.c.d
■ Source IP Address Mask: e.f.g.h
■ Dest. IP Address: 0.0.0.0
■ Dest. IP Address Mask: 0.0.0.0
■ Protocol Type: 0